W rciprecverror 0x15 updating the ips it 0 dating site bonaire
Use of uninitialized value in multiplication (*) at ./config_tools/amc13config line 140. However, seeing some discrepancies in event length between old and new firmwares.
The word count in the AMC13 header (see below) is 0b instead of 0c, with a zero fill word added (correctly) by the AMC13. This should be taken care of by the u TCA backplane, no?
[000000e0] 48 00 49 00 4A 00 4B 00 4C 00 4D 00 4E 00 4F 00 H. MAC Address: : F:9C (Network Research) Nmap scan report for rfc1918.edu (192.168.2.57) Host is up (0.000093s latency).
MAC Address: : F:5C (Network Research) Nmap scan report for rfc1918.edu (192.168.2.56) Host is up (0.000087s latency).
ok so Ive tried various methods now to configure and send BGO commands from AMC13 but I fail completely. Have you tested these versions in the lab recently to make sure you are still able to configure BGO commands such as Resynch (0x4) and see them in the TTC history?
The packages you get from the repos don't work and you have to remove/update to the following rpms: [ and [ evb:: BU_0 Info Spaces: Application Monitoring run 102Version 3.7.4 Failed Page last updated: Thu Feb 18 2016 UTC Caught exception: exception:: Disk Writing 'Failed to get value from EVM at 33001/urn:xdaq-application:lid=12/event Count For Lumi Section?
./store --slot=1 --ip=192.168.1.148 Storing IP addresses to board in slot 1 from host 192.168.1.41 Unable to send RAW command (channel=0x7 netfn=0x32 lun=0x0 cmd=0x40 rsp=0xc3): Timeout substr outside of string at ./config_tools/amc13config line 137.